5
VISION
™
• SCIBORG
®
Where to connect the Antenna Unit Harness on the Control Unit var-
ies by whether you are using the 2460 or 1460/1480, as shown below.
We recommend mounting the Antenna
Unit in open view on the outside of the
driver’s side A-pillar as shown at right.
Remove the plastic pillar cover so you
can hide the wires inside. Then use the
included 2-sided tape to affix it to the
outside of the pillar. Alternatively, you
can use velcro (not included) and affix it to the ceiling, just above the top of
the A-pillar, as most car ceilings are of a fuzzy material that velcro sticks to.
Keep the Antenna Unit out of constant contact with sunlight (heat
negatively affects RF communication), and mount it as far as pos-
sible from metal parts!
Antenna Unit
Antenna Unit
Harness
1460 or 1480 ONLY! Connect Antenna Unit Harness here.
2460 ONLY! Connect Antenna Unit Harness here. (Back Side)
Control Unit
Panic Mode
Panic Mode allows you to trigger the full 30 second siren blast from
your remote, whether the system is Armed or Disarmed. Press But-
ton-I or Button-III for 3 seconds. When you release, vehicle hazard lights
will flash (if supported), the Status LED will flash rapidly, and the siren will
blast for 30s. (Long-pressing Button-II will only flash the Hazard lights for 30
seconds, if supported, but the siren will not trigger.)
To stop Panic Mode and silence the siren, simply press Button I, II or
III for a short duration (1 sec. or less) and release. Note that you must wait
approximately 4 seconds after you initiate Panic Mode before you press Button
I, II or III, otherwise your button press will be ignored and the siren will keep
sounding.
SYSTEM OPERATION
INSTAL L ATION
“A” Pillar
Antenna Unit
