6
© KIRAMEK, INC.
LEARN MODE
Before you can use your remote(s), you must perform a one-time
learn procedure, shown below. The security system can learn up
to 4 remotes total.
1. Disarm, and turn on the Ignition. (1480: LED will flash if a door is open.)
2. Press-and-hold the Program Switch. The Status LED will light. Release
the switch only when the LED turns off and you hear 3 siren chirps (af-
ter about 6 seconds of pressing). All remotes are erased from memory.
3. Press button
. You should then hear 1 chirp.
4. If you have a second remote, learn it now by pressing button
. You
will then hear 2 siren chirps. If you then program a 3rd remote, you
will hear 3 siren chips; and for a 4th remote you will hear 4 siren chirps.
5. Switch off the Ignition. The Status LED will light for 6 seconds and
then turn off. The LED will then flash the same number of times as your
Manual Disarm Code (default = 6). Learning is finished.
If you delay more than 6 seconds after Steps 2 or 3 above, a timeout will
occur and you will need to start over from Step 1.
If at any time you mess up, perform Step 5, then start over from Step 1.
All previously learned remotes will be deleted from memory. If you have
more than one remote, you must re-learn all of them.
IMPORTANT
Transmitter memory is erased whenever you change your Manual Disarm
Code. See “Manual Disarming” in your 1460/1480 Owner’s Guide.
MANUAL DISARM CODE
If you learn a remote today but then buy a new remote a year from now,
you will need to learn your new and old remotes together.
ADDING A NEW REMOTE LATER
