8
VISION 1440B OWNER’S GUIDE
FEATURE PROGRAMMING
Many system features are user-programmable. To pro-
gram features you will need to open the 1440 control
module and use the Program Switch inside.
(If you can-
not access the Control Module, ask your VISION dealer
to set features for you.)
Once you have the control mod-
ule case open, perform the following 3-step procedure to
alter the features shown in
Table-2
below:
1.
Disarm the system.
(Or “Arm-then-Disarm” if repeating this procedure.)
2. Within 5 sec.
of disarming, press and release the Program Switch.
3.
7KH/('LQVLGHWKH&RQWURO0RGXOHZLOOVORZO\ÁDVK5('
Count the
ÁDVKHV
.
:KHQ WKH QXPEHU RI ÁDVKHV PDWFKHV WKH IHDWXUH ´1Rµ \RX
wish to change in
Table-2
,
press the Program Switch again.
The
LED will change from RED to GREEN. The Green LED shows the fea-
WXUH VHWWLQJ KDV EHHQ FKDQJHGWRJJOHG 7KH QXPEHU RI *UHHQ ÁDVKHV
should match the feature number you have chosen. To go back to the
previous setting, Arm the system and repeat this procedure at Step-1.
NOTES:
(1) There is no visual indication to let you know which setting
\RXKDYHFKRVHQ³VLPSO\WHVWWKHV\VWHPWRFRQÀUP\RXUVHOHFWLRQ
(2) If you never press the Program Switch a second time in Step-3 above,
WKH/('ZLOOÁDVKWLPHVDQGWKHQH[LWWKHURXWLQH$UPWKHV\VWHP
and then go back to Step-1 to re-enter feature programming. (3) You
must repeat this procedure for each feature you wish to program.
Program Switch
TABLE-2
Feature Selection Menu
No. Feature Description
Toggle Settings
6
Confirmation Chirps
ON
OFF
7
Vehicle Lights ON During Remote Start
ON
OFF
8
IG Protect Mode / Remote Start C. Mode
IG Protect
RSCM
9
Siren Output
Continuous
Pulsed
10
IIP Trigger Selection
All
Door
13
Error Chirp
ON
OFF
14
Exit Delay Time Selection
5 sec.
40 sec.
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
