-
-
5. LONG-TERM STORAGE
-
-
6. CONTROL PANEL FUNCTION
If store the generator sets for long periods, please store the gen-sets in the dry,
clean and ventilated places. Store as following:
1) Stop engine after engine been running for three minutes. Drain off oil
completely and refill the new oil during the engine is still hot.
2) In order to prevent condensation in the fuel tank, drain off fuel completely, and
remove the sediments.
3) Put lube on the supporting point and connection port of speed regulating
system.
4) Please clean mud, dust and oil remained on the machine surface. If there is
paint stripping place, then respray.
5) Disconnect cable of storage battery from (-) terminal. Please charge the
storage battery once per month to resolve intrinsic shelf depreciation during
machine storage.
6) Must finish periodic check prior to maintenance.
7) Please cover the unit with plastic housing, in order to prevent water or dust
into control box, radiator and muffle of exhaust pipe. And add safeguard for the
outdoor generator.
8) Store the machine in the place without moisture or dust and with good
ventilation.
9) After a long storage, refer to the
“
2 Pre-start preparations
”
before restart the
generator.
About the engine refer to the engine manual.
1. Button function
Setting of various electric parameters display in circle
1) When the generator set is out of trouble, press the
“
Function' button for one or
two seconds, and then the various electric parameters will be displayed in circle.
2) When the electric parameters display is cycling, press the
“
Function' button for
one or two seconds, the generator will quit this state.
Button functionsetting function
1) Press the
“
Function
”
button for five second when starting the generator, it
enters the parameter setting function.
2) Press the
“
Function
”
button to choose the setting you want among the four
kinds below:
(1) Phase setting
(2) Frequency setting
(3) Voltage setting
(4) Current setting
2. Indicator light function:
Battery voltage:
indicating battery voltage.
Running time:
indicating the total running time of generator.
Frequency:
indicating the generator frequency.
Three-phase current:
indicating the generator current.
Single-phase power:
indicating the generator power.
Generator voltage:
indicating generator voltage.
Generator set running:
indicating: indicating whether the power exist.
Running fault:
indicating the running fault of generator, and you can inquire fault
refer to code list.