a. The engine must be at level state when filling lube.
b. Remove the filler cover (orange), refill the
recommendatory oil to the upper limit of the oil
scale.
c. Measure the oil mass with oil gauge. In
order to measure the accurate oil level, first
pull out the oil gauge, clean it and put it in,
then pull out and look at the oil mark, at the same time check if the lube is
contaminated.
d. Start and run the generator for 3-5minutes, then stop it and make sure.
2) Check and refill fuel
Open the fuel filler cover, check the fuel and refill if necessary. Fuel should be
unleaded gasoline.
Stop the generator set before filling fuel.
Do not smoke or allow flames when refilling fuel.
Be careful not to spill fuel when refueling. If any fuel is spilled, clean it with dry
cloth before starting generator.
3) Check the battery voltage
(1) Check battery
The battery of generator set adopts advanced technique without maintenance.
Observe the battery indicator light when check the battery.
Blue: the electricity is enough.
Red: the electricity is not enough, need to charge.
White: replace the battery.
The crankshaft speed is lower than normal when start the engine, it may cause
start failure. Then charge the battery, if can not start the generator, you should
replace the battery.
The electricity is not enough; please charge the battery in time.
Please check the battery voltage before start the generator which has not been
run for three months. Charge the battery with outer charger when the voltage
below 12V. If start at low voltage, the motor may be damaged or burnt out.
(2) Notice for charging battery:
Charge the battery in the well-ventilated place.
First remove the cathode(-) terminal wire, then remove the anode(+) terminal
wire. Connect battery anode then cathode (incorrect connection may produce
spark and ignite inflammable gas in the battery thus leading to explosion.)
-
-
2. KGE12E3 ELECTRICAL WIRING DIAGRAM
-7-
CAUTION