5
5.
Cooperation with controllers
Check controller software version before
connecting a ecoNET300 module with the
controller.
In the controller main menu select tab:
MENU
→
Information
→
Software version
User can contact with the controller
manufacture in order to verify whether a
particular type of controller will be
cooperating with ecoNET300 according to
data concerning controller software versions.
6.
Connection to the controller
The ecoNET300 internet module has to be
connected with controller with the use of
ecoLINK2 interface. In case of some types of
controllers it is necessary to use an
appropriate adapter. The ecoLINK2 interface
and adapter are a part of the ecoNET300 set.
Adapter: 1 - socket for RJ11 ecoLINK2 interface, 2
- a plug for controller module transmission socket,
3 - socket for a control panel plug.
6.1
Connection with ecoMAX850P2
The ecoMAX850P2 controllers are equipped
with just one COM transmission socket in
RJ11 standard which a control panel (located
inside or outside the controller housing) is
connected to. Using one RJ11 socket in the
module requires connecting an additional
divider (telephone RJ11 tee separator) and
additional cable.
Standard divider, RJ11 telephone divider: 1-
connection of RJ11 ecoLINK2 interface plug, 2-
connection of the control panel plug, 3-
connection of an additional cable with two RJ11
terminals.
Standard RJ11 telephone cable with an option of
connecting wires and a method of connecting into
the divider.
Below show location of the controller COM
transmission
socket,
where:
interface
ecoLINK2,on
diagram
includes:
COM
transmission
socket
(connection
point
between cable and divider), divider, control
panel, additional room panel and additional
cable to a divider.
In order to connect the ecoNET300 module
with the controller, ecoLINK2 interface is
required which is a part of the set.
The internet module will cooperate only with
controllers with installed software supporting
ecoNET300 module.
In any circumstances do not modify
construction of the device.
