KINSHOFER AUGERTORQUE SB Series, Operator'S Manual

Page: 36 / 52

36
5. Shut down
1. Set the attachment down on a horizontal and stable surface before
dismantling from the carrier.
2. Switch off the carrier’s drive .
3. Switch on the ignition .
4. Actuate all hydraulic valves in the control circuits for the attachment until all
of the pressure in the attachment or in the hydraulic lines has been
dissipated - then check the system that it is
free of pressure .
5. Secure the attachment or the carrier machine to prevent erroneous or
unauthorised starting up.
6. Disconnect the mechanical and hydraulic connections to the carrier.
NOTICE
Observe further requirements for shutting down as described in the shutting
down chapter as well as on the safety instructions sheet.
WARNING
Health risks
and environmental contamination through escaping oil .
Hydraulic oil may escape from the lines on the attachment and the carrier
machine during dismantling:
•
Position a suitable collecting tray under the hydraulic connections to
collect the oil.
5.1. Dismantling
1. Switch off all supply media , if available, (e.g. hydraulic and electrical).
2. Disconnect the mechanical and hydraulic connections to the carrier.
3. Next, close the hydraulic connections .
WARNING
Health risk
and environmental pollution due to escaping oil .
Hydraulic oil may escape from the lines on the attachment and the carrier
machine during dismantling:
•
Position a suitable collecting tray under the hydraulic connections to
catch the oil.
Procedure
Procedure