8
FIXTURE CONTROL SETTINGS:
To
simultaneously
chase same
lamp position in one or more
fixtures:
•
Set Toggle to
INDV.LAMP.
•
Set address to
“001”.
•
Turn on power switch.
Set the DMX TERMINATE switch on the LAST
Fixture to
“I” CLOSE
. The preceding Fixtures
in the daisy chain must have the switch set to
“O”
Open
.
DMX-ONÉ CONNECTIONS
(A)
Plug in 5 pin XLR DMX cable into DMX
output plug and connect to a fixture’s
DMX Input plug.
(B)
Plug in power cable to DMX-ONÉ AC
power input. (100-240 VAC, 50-60Hz)
DMX ONÉ SETTINGS
(A)
Turn on power switch.
(B)
Set RATE/DIM switch to
DIM
and turn MASTER up to
max.
(C)
Set NUMBER OF
CHANNELS to total number
of
LAMPS PER
FIXTURE
being chased.
(D)
Set RATE/DIM switch to
RATE
.
(E)
The MASTER knob controls
the rate of chase. The same
lamp position in each fixture
will chase simultaneously
throughout the chain.
NOTE:
If a fixture loses its DMX
signal it will hold it’s last DMX
command.
For this reason it is
important to turn off the instrument
through a DMX command.
To turn off a fixture using the DMX
ONÉ:
•
Set RATE/DIM to
DIM.
•
Turn
MASTER down to
Minimum.
•
Turn off power switch.
Summary of Contents for DMX-ONE
Page 1: ...Operation Manual DMX ONÉ ...
