6
FIXTURE CONTROL SETTINGS
To adjust light levels on one or more
Fixtures:
•
Set all Fixtures to address “
001
”
•
Set toggle switch to
FIXTURE.
•
Turn on power switch.
Set the DMX TERMINATE switch on the
LAST Fixture to
“I” CLOSE
. The preceding
Fixtures in the daisy chain must have the
switch set to
“O”
Open
.
DMX-ONÉ CONNECTIONS
(A)
Plug in 5 pin XLR DMX cable into DMX
output plug and connect to a fixture’s
DMX Input plug.
(B)
Plug in power cable to DMX-ONÉ AC
power input. (100-240 VAC, 50-60Hz)
DMX ONÉ SETTINGS
(A)
Turn on power switch.
(B)
Set NUMBER OF CHANNELS
to “
001
”
(C)
Set RATE/DIM switch to
DIM
(D)
Use MASTER knob to control
light level. Lamps will turn off in
a progressive outside in pattern.
NOTE:
If a fixture loses its DMX signal
it will hold it’s last DMX command.
For
this reason it is important to turn off the
instrument through a DMX command.
To turn off a fixture using the DMX
ONÉ:
•
Set RATE/DIM to
DIM.
•
Turn
MASTER down to
Minimum.
•
Turn off power switch.
Summary of Contents for DMX-ONE
Page 1: ...Operation Manual DMX ONÉ ...
