22
7. Operating
Lighting instruction
1) Open the cabinet door, put the gas cylinder into the cabinet Turn the control knob clockwise to “OFF” position.
2) Connect the regulator to the gas bottle. Turn the gas supply “ON” at the cylinder. Check with the use of soapy
water for any gas leakage between the bottle and the regulator
3) Push down the control knob and keep pressing whilst turning anti-clockwise to the “Ignition” position (a click
will be heard), this will light the pilot. If not repeat this process.
4) When the pilot burner is lit, keep the control knob pressed for 5 seconds then release it.
5) If the burner does not stay alight, repeat steps 3 and 4.
If the burner has not lit wait 5 minutes and repeat steps 3 and 4.
6) Adjust the heat setting by turning the control knob to the high or low position.
7) To turn the heater ‘OFF’ turn the cylinder valve or regulator switch to the ‘OFF’ position and then turn the control
knob on the appliance clockwise to the ‘OFF’ position.
Warning:
If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve off.
Wait five minutes before attempting to relight with ignition sequence.
Warning:
What to do after glasses on heaters broken:
A. If the heater is not in use,please dont touch splinters with hands,clean all splinters with tools to avoid anybody
be injured.And ask a professiona man for installation of new glass.
B. When it happened in use,please turn off the cylinder and control valve immediately, clean all splinters with tools
to avoid anybody be injured.And ask a professiona man for installation of new glass.
Switching off the heater
1. Turn the control knob back to PILOT position.
2. Press and turn the variable control knob to OFF position.
3. Turn the gas valve of the gas supply cylinder off again.
8. Cleaning and care
Make sure all the cleaning is done after turn off the heater and cooling down.
Wipe off powder coated surfaces with soft, moist rag.
Do not clean heater with cleaners that are combustible or corrosive.
Remove debris from the burner to keep it clean and safe for use.
Open the top back door to clean debris on glass carefully.
9. Storage
1. Always turn off the gas valve of the gas supply after use or in case of faults.
2. Remove the pressure controller and the gas tube.
3. Always examine the gas tube for damage and leaks.
If you find any damage to the gas valve, the gas dealer must replace it.
4. Pressure tanks with liquid gas must never be stored in the basement
or other locations without sufficient air circulation.
GB-BAHAG KS FEUERSTELLE MANUAL RZ.qxp 20.04.22 12:14 Seite 22
