13
Log Assembly for Models ZV3600 and ZV4200
Log Assembly (LOGC42)
1.Remove glass door by removing two (2) screws behind upper
grills or unfasten latches and lifting door off bottom door
retainer channel.
2.Remove logs from carton (4 pcs) and inspect. (Part
#LOGC42)
3.Verify to see that ember plates (2 pcs) are between front and
back burner, air opening to top (as per diagram). The ember
plates are used to hold the glowing ember, thus simulating a
glowing bed of embers.
4.Place glowing embers (insulation) on surface of front burner
and surface of ember plates.
Height on front burner 1/2” - 3/4”
Height on ember plates 3/4” - 1”
Do not cover back air opening on ember plates.
5.Place rear log on log shelf 1/2” away from back of fireplace.
6.Place front log over front burner, and resting against decora-
tive grate.
7.Place right and left logs across front and back log. Bark
should be to the outside, and right log has a knot.
8.Adjust right and left log so that black charred area sits
between front and rear log.
9.
Make sure that a space of at least 3/4” is maintained
between glowing ember and underside of front log ember
bed area.
10.Front log should be centered on the log supports between the
front and rear burners. Pull log against the front of the sup-
ports.
11.Top logs can then be placed across the front and back logs in
the slots provided.
12.Place decorative moon rock on bottom of fireplace to simulate
ash and then sprinkle vermiculite over rock.
13.Purge lines and test pilot operation.
14.Replace glass door. The door must be installed before operat-
ing the fireplace.
REAR LOG
LEFT LOG
RIGHT LOG
EMBER PLATE
FRONT LOG
LEFT CROSSOVER LOG
Part # 4200-253
REAR LOG
Part # 4200-252
FRONT LOG
Part # 4200-251
FRONT GRATE
FRONT BURNER
ROCK
MINERAL WOOL
LOG SET 4200-250
RIGHT CROSSOVER LOG
Part # 4200-254
BURNER
MOON ROCK
GLOWING
EMBERS
! EMBER PLATE AIR OPENING.
! DO NOT COVER UP !
! LOG MUST BE BROUGHT UP TO
FACE OF FENCE !
! EMBER PLATE AIR OPENING.
MUST NOT BE COVERED !
!OPENING BETWEEN
GLOWING EMBERS AND
UNDERSIDE OF LOG. MUST
NOT BE LESS THAN
3/4 INCH !
MOON ROCK
GLOWING
EMBERS
DO NOT PLACE DECORATIVE
ROCK ON BURNERS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.