MP42RL -Brick Liner Installation- When using MP42GT Glass Tray
NOTE: Brick Liner MUST BE CUT and installed
AFTER MP42GT is installed.
NOTE: Either Baffle (MCVST42-H Ceramic Glass
Units) or Deflectors (MCVST42 Tempered Glass
Units) must be removed. Refer to
Baffle Removal / Deflector
Removal
sections of manual.
1.
Remove Baffle (MCVST42-H Ceramic
Glass Units or Deflectors (MCVST42
Tempered Glass Units).
Refer to
Baffle Removal / Deflector
Removal
sections of manual.
2.
Orient tabs in upper firebox as shown.
3.
Install MP42GT. Refer to
MP42GT Installation /
Removal
section.
4.
Cut MP42RL Liner as shown above.
- Use caution as Brick Liners are Fragile. -
5.
Insert Liner into Firebox.
6.
Bend Tabs down over Brick Liner.
7.
Reinstall all components.
Cut Bottom of Liner as shown below.
⚠
WARNING:
Failure to position the parts in
accordance with these diagrams or failure to
use only parts specifically approved with this
appliance may result in property damage or
personal injury
.
Tab
Tab
Tab
Tab
21-1/8”
20-13/16”
21
Summary of Contents for Marquis MCVP42LP
