INSTALLATION OF BRICK PANEL KIT
13
PART: FDV300RL
1. Remove the top, front, and glass door as shown in door removal diagram.
2. The rear log holder has to be removed to install rear brick panel; using a 1/4” nut driver remove the three hex
screws.
3. Hold the rear brick panel with both hands on the left-right of panel, tilt the top panel towards you slightly and pull
your right hand towards you slightly and place panel onto the rear of the firebox. NOTE: TAKE CARE NOT TO
DAMAGE PILOT ASSEMBLY WHEN PLACING REAR PANEL.
4. Loosen both brick clips using 1/4” nut driver. Swing brick clip out of the way and position side brick panel up to
rear brick panel and against side of firebox and tighten brick clip down onto panel, repeat this step with the other
side panel.
5. Reinstall rear log holder with the 3 screws.
6. Install log set and front door as per log and door assembly.
