Whenever being outdoors alone, keep distance from the flames or sources of fire
and proceed as follows.
1)
Place the heater in a correct position of gas filled cylinderr
2)
Clip on the gas regulator to the gas cylinder (fit for 15kg gas cylinder)
3)
Turn the regulator on.
4)
Where the regulator is not supplied please contact your gas dealer to advise of
correct type for the gas cylinder being used.
5)
To avoid of twisting the hose,please make sure to connect the hose with regulator
and heater smoothly
6)
The length of hose not less than 50cm,PVC or Rubber type, comply with
BS3212-Class 2/EN1763-1-Class 3 / EN16436-1:2014+A1:2015
7)
IMPORTANT TEST FOR LEAKS:
8)
This must be carried out in a well-ventilated area, free from naked flames and any
other sources of ignition. With the regulator connected to the cylinder turn on the
regulator control. Brush all hose connections, pipe connections to the valve and gas
cylinder valve with a 50:50 solution of detergent and water. A stream of bubbles
forming indicates a leak. If a leak is found turn off at the regulator and disconnect
the regulator from the bottle and remove the gas cylinder outdoors or to a well
ventilated area. Contact your gas supplier for assistance. DO NOT USE THE
HEATER.
9)
After leak testing is satisfactorily carried out close the back door of the heater. It
may be necessary to move the heater slightly to allow the regulator and hose to fit in
the back without kinking the hose
10) Need to regular checking and if necessary replacement the hose
Noted: Place cylinder in a proper and safe place
HOW TO CHANGE A CYLINDER
1. Cylinders must be replaced in a non-flammable and non-smoking environment.
2. Close the gas bottle valve,
3. Unscrew the regulator from the Valve from the cylinder and remove the appliance, take
the empty cylinder away from the heater.
4. Find our if there is pressure controller sealing in place.
5. put the appliance on a new gas bottle and continue as specified in “Instructions for
installation and putting the appliance into operation”.
6.
Following the steps described under “connecting the cylinder”, connect a new cylinder.
6
Summary of Contents for KF-009D-03
Page 13: ...12 ...
