KING PHOENIX KPD1000, Owner'S Manual

Page: 9 / 24

Page 9
SEALANT
KC1397
SEALANT
KC1397
KC1424
Stow
Plate
KC1424
Stow
Plate
MOUNT THE UNIT
MOUNT THE STOW PLATE
1 . Loosen foot nuts . Rotate feet into mounting position
(they should look like illustration at right) . Re-tighten
foot nuts .
4 . Mount the unit using foot mounting holes and any additional mounting holes you drilled .
2 . If the fasteners you have chosen require pilot holes, place
the unit in its location and use the foot holes to mark the
pilot hole locations . Drill pilot holes .
3 . Apply roof-compatible sealant to roof around entire area where fasteners will penetrate the roof .
5 . Seal all fastener heads and foot perimeter with roof-compatible sealant .
1 . Apply roof-compatible sealant
around perimeter of stow plate .
Make an “X” with sealant in the
middle .
2. Press stow plate firmly into place.
Take all necessary safety precautions
when lifting the unit up to the roof.
The stow plate mounts 16” in
front of the base mount body.
!
!
Depending on your roof, you may wish to use fasteners in combination with the sealant.
The installer is responsible for determining the best fasteners, and for waterproofing all holes
and sealing all fastener heads.
!
In the event your fasteners do not align with roof beams, it is highly recommended you
drill extra holes in the mounting feet for additional mounting strength .
TIP
KC1403 KC1403
Roof-compatible sealant.
!
16”