KING PHOENIX KPD1000, Owner'S Manual

Page: 8 / 24

Page 8
Roof cross beams
KC1389
Roof cross beams
Front of
Vehicle
Roof cross beams
KC1389
Roof cross beams
Front of
Vehicle
KC1387 KC1387
Front of
Vehicle
Overhead view with dish lowered
KC1396
Front of
Vehicle
Overhead view with dish lowered
KC1396
The unit should be no more than
3 degrees from level .
Rotational clearance from
center rotation point is 26” when
dish is elevated and rotating .
This is a safety zone . Anything
higher than 6” within this zone
is at risk .
When lowered, the dish must
face the rear of the vehicle to
avoid damage to unit while
vehicle is in motion .
37”
26” R
33 .5”
The installation area must be clean to ensure good sealing to the roof .
Identify interior location for controller and ensure the 30’ cable will reach between the
controller and the antenna unit .
At least two mounting feet should be
over roof support beams .
Fasteners from at least two mounting
feet should penetrate the roof beams,
ideally toward the front of the vehicle .
Make sure mounting screws will not damage any interior roof wiring or tubing when installed .
DETERMINE ROOF LOCATION
1 . Determine the mounting location based on the following:
A
B
C
D
E
F
All of the following points are important.
!