KING PHOENIX KPD1000, Owner'S Manual

Page: 10 / 24

Page 10
4 . Make a service loop in the wiring and run it to where it will enter the vehicle .
1 . Run control cable and coax from antenna unit to junction box location .
3 . Place wiring connections inside the junction box and install junction box to roof . Seal properly .
7 . Screw clam shell cover over hole . Seal properly .
8 . Secure wiring to roof every 12”-18 .” Seal properly .
5 . Drill a 1 inch hole in the roof where the cabling will enter vehicle .
6 . Feed wiring thru hole into vehicle interior . Seal hole properly .
2 . Fill coax connector with grease . Connect antenna unit coax to roof coax . Plug in control cables .
Step 5: When drilling thru roof, proceed slowly, making
sure no cables or critical components will be damaged.
!
Step 3: Fully seal screw holes and seal around junction box.
!
Steps 6 and 7: Fully seal wiring hole.
Fully seal screw holes and around clam shell cover.
!
Step 8: Fully seal all wiring clamps and screws.
!
Step 2: Fill coax connector with dielectric grease to prevent corrosion.
Do not over-tighten coax connector.
!
ROUTE WIRING (Steps 1-8 use illustration on next page.)