7
For better stability,
Sparco System may be
mounted on a treated
wood base using
Phillips pan head
screws,
one in front
and one in back. If you
have questions about stability, please contact
your dealer or King Technology.
4.
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread
Sealant
Two 2” Threaded by
1 ½” Threaded Male
Adapters
Two Hose Adapters
1½” x 1½” x 1¼”
Two Sections of 1½”
or 1¼” Flex Hose (one
provided with filter)
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under
chlorination, replace eyeball
fittings in the return jets to a
smaller or larger size to adjust
back pressure. For best results
use King Technology’s pressure
gauge, order part number
01-22-4000.
Following pipe thread sealant directions, brush
sealant on to Sparco System threads in both
ports and both male adapters.
AUTOMATIC
WATER
TREATMENT
SYSTEM
AUTOMATIC
WATER
TREATMENT
SYSTEM
AUTOMATIC
WATER
TREATMENT
SYSTEM
AUTOMATIC
WATER
TREATMENT
SYSTEM
Screw adapters into each end of Sparco System.
Hand tighten. Finish tightening by turning 1 to 2
revolutions with pipe wrench.
DO NOT OVER TIGHTEN.
Screw a male adapter into each port of the
Sparco System. Hand tighten. Finish tightening
by turning 1 to 2 revolutions with a pipe wrench.
DO NOT OVER TIGHTEN.
Apply sealant to threaded ends of both hose
adapters and inside of both male adapters.
Attach the filter section of flex hose to one hose
adapter and the return section of flex hose to
the other hose adapter with clamps and tighten
with screwdriver. Bi-flow valve design allows
water flow in either direction.
To prevent damage to heaters or filters, see your
dealer about installing a
corrosion resistant
check valve
which will reduce the back flow of
chlorine gas when the Sparco System is turned off.
Base Flex-Hose Installation
6.
5.
3.
1.
2.
DO NOT USE PIPE THREAD TAPE
as the threads on these units are
not suitable for this use and leaking
or fitting failure could result.
The Sparco System should always be installed
between the filter and pool (or between heater
and pool if applicable).
Never install Sparco
System before the heater or damage to the
heater could occur.
Install
