9
1½” Male Adapter
(slip x MPT)
or
2” Female
Adapter
(slip x FPT)
Hard-Plumbed Installation
Do NOT install FROG
Leap off-line.
Following Primer directions, brush Primer on the inside of the
adapters and to ends of pipe. Repeat this process with PVC
cement following manufacturer’s directions on that product.
Measure the distance
between the outside
adapters and cut out a
section of pipe 3” less
than that dimension.
Allow a minimum of
12” above and on
each side of FROG
Leap Infuzer to
ensure room for easy
replacement of FROG
Leap Anti-Bac Mineral
Pac and FROG Leap
Torpedo Pac.
Insert PVC pipe into adapters with
a twisting action. Hold in place 5 to
10 seconds to bond.
TOOLS NEEDED
Hacksaw
MATERIALS NEEDED
Tape
Measure
SECURE INFUZER
To prevent damage to heaters
or fi lters, see your dealer about
installing a
corrosion resistant
check valve
which will reduce the
back fl ow of chlorine gas when the
Infuzer is turned off.
1.
2a.
2.
2b.
3.
Pipe Wrench
Bi-fl ow valve design allows
installation in either fl ow
direction.
Pipe Thread Tape
or Sealant, Primer and
PVC Cement
If using
male adapters
, apply
pipe thread tape or sealant to the
threaded end of each adapter.
Screw adapters into each end of FROG Leap Infuzer following directions
for a male adapter or a female adapter. Hand tighten. Finish
tightening by turning 1 to 2 revolutions with a pipe wrench.
DO NOT OVER TIGHTEN.
4.
5.
Do NOT install in copper pipe if using
FROG Leap Torpedo Pac as chemical
corrosion may lead to pipe failure.
Primer
For better stability,
FROG Leap Infuzer
may be mounted on
a treated wood base
using
Phillips pan head
screws,
one in front
and two in back. If you
have questions about
stability, please contact
your dealer or King
Technology.
Primer
PVC
Cement
PVC
Cement
12"
12"
12"
If using
female adapters
, apply
pipe thread tape or sealant to the
threaded end of each feeder port.
OR
The FROG Leap Infuzer should always be installed between
the fi lter and pool (or between heater and pool if applicable).
Never install
FROG Leap Infuzer
before the heater or
damage to the heater could occur.
Install