7
TOOLS NEEDED
Screwdriver
Pipe Wrench
INCLUDED WITH FROG Leap
Infuzer
Pipe Thread Tape
or Sealant
One 6” X 1½” TBE PVC
Nipple
MATERIALS NEEDED
One Hose Adapter
1½” X 1½” X 1¼”
One Section of
1½ or 1¼” Flex Hose
One
Hose Clamp
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eyeball fi ttings in the
return jets to a smaller or larger
size to adjust back pressure. For
best results use King Technology’s
pressure gauge, order part number
01-22-4000.
Filter Flex-Hose Installation
Apply pipe thread tape or
sealant to each threaded
end of nipple.
1.
Screw either side of
FROG Leap Infuzer on
to open nipple end until
upright and secure.
Apply pipe thread tape or
sealant to threaded end of
hose adapter.
3.
4.
Screw adapter into the other
side of FROG Leap Infuzer.
Hand tighten. Finish tightening
by turning 1 to 2 revolutions
with a pipe wrench.
DO NOT OVER TIGHTEN
.
5.
6.
Attach return section of hose to
the adapter with clamp. Tighten
clamp with screwdriver.
7.
To prevent damage to heaters
or fi lters, see your dealer about
installing a
corrosion resistant
check valve
which will reduce
the back fl ow of chlorine gas
when the Infuzer is turned off.
Install
Screw one end of nipple
into the fi lter return. Hand
tighten. Finish tightening by
turning 1 to 2 revolutions
with a pipe wrench.
DO NOT OVER TIGHTEN.
2.
