SETTING FENCE AT A 90
0
ANGLE
1.
Before adjusting the fence at a 90
0
angle, adjust the positionning of the infeed
table. Adjust the infeed table so that it is parallel with the outfeed table.
2.
Loosen the lock lever (A). Move the fence towards the front of the machine so
that it leans on the table.
3.
Place a straight edge ruler on the table and against the fence.
4.
Verify to see if the fence is at a 90
0
angle to the table.
5.
If the fence is not at a 90
0
angle to the table, please use the following instructions;
6.
Loosen the stop nut (B), flip the 90
0
set plate (C) and screw in stop bolt (D) and
adjust the fence to a 90
0
angle with your straight edge ruler.
7.
Replace set plate, unscrew stop bolt until it touches the set plate and tighten the stop
nut (B) after having adjusted the fence at a 90
0
angle.
STOP NUT (B)
LOCK LEVER (A)
SET PLATE (C)
STOP BOLT (D)
