ELECTRICAL & TECHNICAL
INFORMATION
ELECTRICAL INFORMATION
WARNING!
ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN
. FAILURE TO COMPLY MAY RESULT IN SERIOUS
INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE METAL LATHE DISCONNECTED FROM THE POWER SOURCE.
FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!
POWER SUPPLY
WARNING:
THIS METAL LATHE MUST BE ‘HARDWIRED’ (connected directly to the circuit breaker without the use of a plug). We recommend
that only a qualified electrician do the initial ‘Hardwiring’ of this metal lathe.
WARNING:
YOUR METAL LATHE MUST BE CONNECTED TO A 240V, 15-AMP (MINIMUM) BRANCH CIRCUIT WITH A 15-AMP TIME DELAY FUSE
OR CIRCUIT BREAKER. FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY FROM SHOCK OR FIRE.
THIS METAL LATHE MUST BE GROUNDED
. IF NOT PROPERLY GROUNDED, THIS METAL LATHE CAN CAUSE ELECTRICAL SHOCK,
PARTICULARLY WHEN USED IN DAMP LOCATIONS. TO AVOID SHOCK OR FIRE, IF THE POWER CORD IS WORN OR DAMAGED IN
ANY WAY, HAVE IT REPLACED IMMEDIATELY.
TECHNICAL INFORMATION KC-1440ML
Main Specifications
Max. swing over bed ......................................................................................................................................................................14” (355mm)
Max. swing over saddle gap ....................................................................................................................................................20-1/4” (514mm)
Max. swing over cross slide ......................................................................................................................................................8-5/8” (219mm)
Distance between centers............................................................................................................................................................40” (1016mm)
Headstock
Spindle bore diameter................................................................................................................................................................1-7/16” (37mm)
Spindle bore taper ....................................................................................................................................................................................MT#5
Spindle speed range ............................................................................................................................................................8 (70-2000 R.P.M.)
Gear Box
Thread cutting: ......................................................................................................................................................................Inches (4-56 T.P.I.)
...................................................................................................................................................................................... Metric (0.4 - 7mm)
Tool Post, Saddle, Tailstock
Top Slide travel ............................................................................................................................................................................3-1/2” (88mm)
Cross Slide travel ....................................................................................................................................................................6-3/16” (157mm)
Tailstock taper............................................................................................................................................................................................MT#3
Tailstock quill travel ..........................................................................................................................................................................4” (100mm)
Diameter of Tailstock quill ............................................................................................................................................................1-1/4” (32mm)
Motor
Horsepower ................................................................................................................................................................................................2 HP
Voltage ........................................................................................................................................................................................240V, 1 phase
Amperage ..............................................................................................................................................................................................11 amp.
Motor R.P.M.....................................................................................................................................................................................1720 R.P.M.
Motor frequency..........................................................................................................................................................................................60Hz
