ASSEMBLY
bASE, COLUMN & TAbLE ASSEMbLY continued...
9) Locate the crank handle (A) Fig.9 and install it on the worm gear shaft
on the side of the table support. Tighten the hex. bolt (B) on the flat
section of the worm gear shaft.
10) Install the table support lock handle (C) Fig.9 to the table support as
shown.
11) Install the table lock handle (A) Fig.10 to the table support (B) as
shown. Do not tighten.
12) Slide the table (C) Fig.10 into the opening of the table support.
Tighten table lock handle (A).
INSTALLING THE HEAD
Warning!
The drill press head is very heavy, it is not recommended to
attempt installation of the head by yourself, obtain help.
1) Carefully lift the head (A) Fig.11 above the column (B) and slide it down
on the column as far as it will go. Align the head with the table and the
base.
2) Using a 5 mm hex. key, tighten both head set screws (C) on the right
side of the head.
FIGURE 9
FIGURE 10
FIGURE 11
