5
EN
28 mm
Fig. 4
04.
Fix the bracket in place using suitable plugs, screws and washers
(not supplied)
3.5.2
–
Installation of the front fixing
bracket
01.
For the installation of the front bracket to the gate leaf, refer to
distance D
(fig. 2)
.
02.
Define the front bracket installation height in accordance with
fig. 4
;
03.
Fix the bracket to the solid section of the gate leaf.
3.5.3
–
Securing the gearmotor to the
fixing brackets
•
Secure the gearmotor to the rear bracket:
Note: if the rear bracket is not completely level, the back tilting
section can help compensate for any axis misalignments
between the two brackets (+/-5°).
- 5°
+ 5°
Fig. 5
01.
Secure the gearmotor to the bracket as shown in
fig. 6
, using the
screw, washer and nut supplied;
02.
Fully tighten the nut and then loosen it again by approximately
1/10 of a turn, to allow a minimum clearance between the parts.
1
2
Fig. 6
•
Secure the gearmotor to the front bracket:
01.
Secure the gearmotor to the bracket as shown in
fig. 7
, using the
screw and the washer supplied;
1
2
3
Fig. 7
02.
Fully tighten the screw;
• JET XL
Adjust the gearmotor
opening
and
closing
strokes:
01.
Release the gearmotor as shown in
fig. 8
;
1
3
2
4
Fig. 8
02.
Remove the 2 screws underneath the handle and remove the
cover as shown in
fig. 9
.
1
2
Fig. 9
