King-Dome 9704-LP, Installation And Operating Instructions Manual

Page: 29 / 40

Page 27
IMPORTANT! YOU MUST HAVE COMPLETED THE ANTENNA CONFIGURATION (PAGE 13), AND PERFORMED
A SUCCESSFUL SEARCH (STEP 2 BELOW), BEFORE RUNNING THE CHECK SWITCH
(STEP 3 BELOW).
Note: For automatic satellite switching, King Controls recommends using a Dish Network model 311 receiver for Dish
500, and a Dish Network model VIP211 or a VIP211k HDTV receiver for Dish HD Eastern Arc /
Dish HD Western Arc with Locals / Dish HD Eastern Arc with Locals / Dish HD Alternate with Locals.
Do not use dual tuner receivers or receivers with built-in recorders.
If you do not have a clear view of the satellites, the switch will not load correctly.
The SW21 and SW64 switches are a receiver software configuration that is loaded into the receiver after
running a check switch test with the dish locked on and configured for the appropriate service.
This one time procedure will not need to be repeated after successful installation, unless
a) check switch test is run again while connected to a home dish system.
b) check switch is run when a receiver is not connected.
c) you travel outside the coverage area of the pre-set satellite trio and switch trios (Dish HD Western Arc with
Locals/Dish HD Eastern Arc with Locals).
d) you are parked in an area where the selected satellites are blocked, but are able to select alternate
satellites and get signal.
STEP 3: DISH AND BELL TV CHECK SWITCH PROCEDURE
1. Turn on the TV and satellite receiver.
2. On the King-Dome controller, press and hold the
ON button for 3 FULL SECONDS .
The antenna will lock onto all the appropriate satellites
before completing the search process.
After the satellites have been located and the acquisition process is complete,
the status light will be steady green.
If the antenna cannot acquire the designated satellites, you may have to choose an
alternate satellite option. See pages 14-15 for details.
3. On the receiver remote, press Menu, 6, 1, 1.
4. Highlight Check Switch and press select.
Note: Some receivers may prompt you to select
check switch a second time to initiate the test.
(Continued on next page)
Screen graphics may vary.