UNPACKING & ASSEMBLING
YOUR VACUUM
ATTENTION! The vacuum accessories are packed inside
the vacuum tank.
UNPACKING YOUR VACUUM
Remove the entire contents of the carton
, please note that most of
the accessories are packed inside the vacuum tank. To access these
accessories, push the cover latches (step 1) Fig.3 inward, lift the tank
cover/motor assembly (step 2) and then remove the accessories inside
the tank.
WARNING!
DO NOT CONNECT THE POWER CORD TO THE POWER SOURCE UNTIL THE
FOLLOWING ASSEMBLY AND SET-UP INSTRUCTIONS HAVE BEEN DONE.
ASSEMBLING LARGE WHEELS AND CASTER WHEELS
Two large 8” wheels and two caster wheels are included and should be assembled to the
bottom of the base.
1) With the tank cover/motor assembly removed, turn the tank upside down. Insert the caster
wheels into the two openings in the base and apply pressure until casters snap into place.
2) To assemble the large wheels to the base, first insert the wheel shaft (A) Fig.4 into the rear
support block, slide a washer (B) on the shaft, then slide wheel (C) on the shaft, then
another washer (B). Insert cotter pin (D) into the hole at the end of the shaft to lock wheel.
Snap the wheel hub (E) onto the wheel. Repeat these steps to install the other wheel.
TRANSPORT HANDLE ASSEMBLY
A transport handle is included and should be assembled to the mounting brackets on the sides
of the stainless steel tank assembly.
1) Insert both ends of the transport handle into the mounting brackets on the sides of the
stainless steel tank, push down until each lock pin clicks in place. See Fig.5.
NOISE DIFFUSER ASSEMBLY
For quiet operation, a noise diffuser is included and should be installed to the rear blower outlet.
1) Install the noise diffuser (A) Fig.6 into the blower outlet (B) by inserting the locking end and
turning clockwise to lock it in place.
ACCESSORY STORAGE BAG ASSEMBLY
An accessory storage bag is included and should be installed to the transport handle.
1) Install the storage bag to the transport handle using the retaining clips as shown in Fig.7.
HOSE, WANDS AND ACCESSORY ASSEMBLY
1) Install the locking end of the flex hose Fig.8 to the vacuum inlet (front of the vacuum) by
inserting the locking end and turning clockwise to lock it in place.
2) Assemble the 2 extension wands and the contour handle with air
control together and then attach the flex hose to the contour handle.
3) Attach either the floor sweep Fig.8, crevice tool or gulper tool to the
other end of the extension wand assembly.
Figure 4
Figure 5
Figure 6
Figure 7
Figure 3
Figure 8
