Kinetico ERGO RO BLUE, Instructions For Use Manual

Page: 22 / 36

TM
22
1. TECHNICAL CHARACTERISTICS
(*) For salinity levels above 2000 ppm, please check with your distributor. Warning: A high salinity rate and/or low
inlet pressure may cause the unit to operate outside of its working limits thus substantially limiting or preventing
the reverse osmosis process.
(**) For maximum performance and longevity of components.
In the event of any queries in relation to installation, use or maintenance of this equipment, please contact your
distributor’s technical assistance service (S.A.T).
2. PRIOR WARNINGS
Warning: This equipment IS NOT A WATER PURIFIER.
In the event of the water to be treated coming from
a public water supply (and therefore meeting current
legislation requirements), this equipment will substantially
improve the water quality.
Warning: In the event of the water to be treated not co-
ming from a public water supply or from an unknown
source, a physico-chemical and bacteria analysis of
the water. Should be completed in order to ensure the co-
rrect purification process and by applying the appropriate
techniques and equipment as necessary PRIOR TO THE INS-
TALLATION of the equipment. Please contact your distribu-
tor in order to receive advice on appropriate treatment.
2.1 CONDITIONS FOR THE CORRECT WORKING OF
EQUIPMENT
• The system should not be used with hot water (T>40ºC).
• The ambient temperature must be between 4º and 45ºC.
• Units of the PUMP series come with a pump. In the event
of the water supply pressure being in excess of 2.5 bar, a
pressure regulator should be incorporated prior to the
appliance, set to a maximum pressure of 2.5 bar (if the unit
does not come with one).
• Equipments of the SO series do not come with a pump.
We recommend its installation when inlet pressure is above
2.5 bar.
• For water with salinity concentration above 2000 ppm
please consult with your dealer.