Kimray DUMP, Installation, Operation, Maintenance Manual, Page: 4 / 32

www.kimray.com
OIL & WATER VALVES
Installation, Operation & Maintenance Guide
4
Model: TREATER / DUMP
ǂ Configuration of Water Valve is a trademark of Kimray, Inc.
WARNING:
DO NOT exceed the maximum pressure specified on the
nameplate. Under no circumstances should the regulator
supply pressure ever exceed the maximum psig.
A4 Maintenance
Maintenance should be performed on a regular basis.
Initial intervals of 12 months is recommended. The
maintenance interval may increase or decrease
depending on changing application environments. The
valve can be repaired without being removed from the
piPing.
Related Publications
The following publications are applicable for the regulator
Number Type Title
Catalog Pages D:10.1-5
Abbreviations / Acronyms
The abbreviations that follow are used in this manual.
Term Definition
SWA Screwed, Water, Angle
FWA Flanged, Water, Angle
Commonly Replaced Parts
• Trim Set
• Diaphragm
• O-Ring
Occasional Replacement Parts
• Body
A5 Changes and Updates
A Before you start
CAUTION:
The instructions provided herein should be completely
reviewed and understood before operating or reparing this
equipment. All CAUTION and WARNING notes must be
strickly observed to prevent personal injury or equipment
damage.
A1 Scope
NOTE:
Do not install, operate, or maintain a treater valve
without being fully trained and qualified with the Kimray
installation, operation and maintenance manual.
To avoid personal injury or property damage, it is
important to carefully read, understand, and follow all the
contents of this manual, including all safety cautions and
warnings.
If you have any questions about this manual, contact
your Kimray applications support group before proceed-
ing.
A2 Introduction
This repair manual contains information for the SWA and
FWA treater valves.
A3 Description
The Kimray treater valve is designed as an oil or water
valve for emulsion treaters, water knockouts and
gunbarrels. The treater valve is ideal for salt water
disposal syStems.
CAUTION:
When ordered, the treater valve Configuration and
construction materials were selected to meet specific
pressure, temperature, pressure drop and fluid conditions.
Since some Body / trim material combinations are limited
in their pressure drop and temperature ranges, do not
subject the pressure regulator to any other conditions
without first contacting the Kimray Inc, sales office or a
sales / applications representative.