Kimray DUMP, Installation, Operation, Maintenance Manual, Page: 26 / 32

www.kimray.com
OIL & WATER VALVES
Installation, Operation & Maintenance Guide
26
Model: TREATER / DUMP
18 Plug and Stuffing Box
Install the Gasket on the Plug making sure the Gasket
rests against the shoulder of the Plug.
See Fig. 18-1
NOTE:
Use all purpose grease on both sides of the Gasket just
before the Plug is installed.
Tighten Plug from 20-25 ft/lbs torque.
19 Lever Hub
Install the Washer onto the Shaft.
Install the Gasket onto the Shaft.
Install the Stuffing Box onto the Shaft.
Install the Packing Ring onto the Shaft.
Install the Teflon Packing onto the Shaft.
Install the Packing Follower onto the Shaft.
Install the Nut onto the Shaft.
See Fig. 19-1
Washer
NOTE:
If getting the Hub on Shaft becomes difficult after the Key
is inserted, place Hub on first and gently hammer Key in
until Shaft and Hub are flush.
Gasket Stuffing
Box
Packing
Ring
Teflon
Packing
Packing
Follower
Nut
ASSEMBLY
Fig. 18-1
Fig. 19-1
✴
✴
✴ ✴