Kimex 049-3W Series, Installation Manual

Page: 21 / 28

6
Mains connection
already wired 230V/AC
External IR connection
Trigger input
Port RS485
Screen operation
Use the supplied power cord to connect the display to the power supply.
Make sure the power supply is correct (230V / AC). Do not lay the cable on hot
surfaces and avoid unnecessary tension.
The display comes with an infrared remote control and a radio remote control.
Plug the jack plug into the "External IR Connection" connector on the left side of
the crankcase and align the receiver so that it has free visual contact with the IR
remote control.
U
se of commands
1. Press the "Up" button on the remote control. The screen will
automatically move to the upper end position and stop
automatically.
2. Press the “ Stop” button on the remote control. Screen
movement stops immediately.
3. Press the
“Down”
button on the remote control. The screen
will automatically move to the lower end position and stop
automatically.