General
Parametre
Specification
Control Modes
Automatic, Manual, Purge, Stop
Heater Capability
750 W
Circulating Fluid
Distilled or Sterile Water
Reservoir Capacity
3 liters for initial set up
Water flow rate (total)
0 .5 - 8 .0 liter/min
Patient Probe Type
YSI 400 Series compatible
Number of Patient Probes
2 (Patient Probe , the primary probe which
controls temperature; Patient Temperature 2, the
secondary probe which monitors only)
Patient Temperature
0°C to 42°C (50ºF to 07 .6ºF)
Display Range
0 .°C/ºF
Resolution
Patient Temperature
±0 .2°C/°F (32°C to 38°C) (89 .6ºF to 00 .4ºF)
Measurement Accuracy
±0 .4°C (lower boundary to 32°C/89 .6ºF)
±0 .4°C (38°C/00 .4ºF to upper boundary)
(includes 0 .°C/ºF external probe)
Patient Temperature Control
33°C to 37°C (9 .4ºF to 98 .6ºF)
Range - Automatic Mode
In 0 .°C/ºF increments
Water Temperature Display
3°C to 45°C (37 .4ºF to 3ºF)
Range Resolution
°C/ºF
Water Temperature Control
20°C to 42°C (68ºF to 07 .6ºF)
Range - Manual Mode
In 0 .°C/F increments
Maximum Water Temperature
32°C to 42°C (89 .6ºF to 07 .6ºF)
(Automatic Mode)
In °C/F increments
Minimum Water Temperature
20°C to 32°C (68ºF to 90ºF)
(Automatic Mode)
In °C/F increments
Mains Input
†
5VAC, 60 Hz, 8 A (nominal)
Current Leakage
< 300uA
Circuit Breaker
2 A Amp (5V)
†
Mains supply voltage fluctuations are not to exceed ±10% of nominal supply voltage.
Appendix D —
Specification
Table
5
K
imberly
-c
larK
* Patient Warming Systems
M000 Control Unit Operator’s Manual: U .S .