6
Attaching / detaching bit and bit type
Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and detached (single finger
notion type) select such a bit whose shank is equal to the size shown below.
Insert the power plug into a receptacle and set the changeover switch to “
F
”
position.
Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to start the motor
running.
When the screw is
tightened
and reach the torque that you had set,
the
tool will
be
stopped automatically.
To reset the tool by releasing the lever to the original position or releasing the bit
from
the screw head.
To return the screw, set the changeover switch to “
R
” position.
Maintenance and Inspection:
1.
The screw driver must be operated in top condition, one day working hour must be not more than eight hours.
cording to operating frequency and torque loaded, we suggest adding lubricating oils in clutch per 3-6 months,
and kindly contact with distributor when product's maintenance .
2.
Please note don’t let the motor get over heated, every minute use 10~15 screws to operate.
3.
The frequency use of this electric screw driver is over than eight hours a day, still it needs periodically testing and treatment.
Every 5-6 months.
4.
Inspect tool cords periodically and if damaged, have them repaired by an authorized service facility. Inspect extension cords
periodically and replace if damaged.
5.
Do not remove any labels. Replace any damaged label.
Description of Operation
Servicing
