5
1) Whenever changing a bit, make certain the Forward / Reverse Switch is in the “OFF “position and tool is unplugged.
2) Do not allow chemicals such as acetone, benzene, thinner, trichloroethylene ketone, or other similar chemicals to
come in contact with the screwdriver housing as damage will result.
3) Do not drop or abuse the screwdriver.
4) Do not adjust the torque setting higher than 8 on the torque scale.
5) There should be a tool rest interval when cycles three seconds or longer. This tool is intended for a duty cycle of 1.0 sec on, 3.0
sec off.
6) Do not use this screwdriver for tightening wood screws. This is “Metal Assembly Screw Driver”
7) Do not operate the Forward / Reverse Switch the motor is running.
8) Whenever a tool is not being used, move the Forward / Reverse Switch to the “OFF” position and unplug the screwdriver.
9) Don't touch For&Rew Switch during operating for keeping system from wrong judgment.
● Do not drop or abuse the tool.
● Whenever a tool is not being used, position the Power Switch to the “OFF” position and unplug the power cord.
(1). LED Light : Indicate OK/NG
。
(2). LED Display : Counting or Setting Value Display , Please refer to Page 8~10
。
(3). Function Key button : For setting and control, Please refer to Page 8~10
。
(4). Forward/Reverse Switch : To switch screwdriver run in Reserve or Forward
R : Run in reserve to untighten screw
。
F : Run in Froward to tighten screw
。
(5). Level switch : Press and hold to start screwdriver, release to stop
。
(6). Front Locking Ring : To fixed the housing of screwdriver
。
(7). Torque Adjusting Ring : To adjust torque from low
(scale 0) to high (scale 8) torque
。
(8). Bit holder cap : Pull out to put bit into the holder
or take out from the holder
。
Slow speed (rpm) operation frequency Slow speed (rpm) operation frequency Slow speed (rpm) operation frequency
900
1.0 ON 3.0 OFF
600
1.0 ON 3.0 OFF
300
2.0 ON 5.0 OFF
850
1.0 ON 3.0 OFF
550
2.0 ON 5.0 OFF
250
2.0 ON 5.0 OFF
800
1.0 ON 3.0 OFF
500
2.0 ON 5.0 OFF
200
2.0 ON 5.0 OFF
750
1.0 ON 3.0 OFF
450
2.0 ON 5.0 OFF
150
2.0 ON 5.0 OFF
700
1.0 ON 3.0 OFF
400
2.0 ON 5.0 OFF
100
2.0 ON 5.0 OFF
650
1.0 ON 3.0 OFF
350
2.0 ON 5.0 OFF
Operations Cautions
CAUTION
Function Discription
Slow speed Duty Cycle Conversion (for reference)
Based on 1000 rpm, 1 second ON/3 seconds OFF. For example, the duty cycle for 350rpm,1000-350=650
，
650/1000%=65%
ON= 1*1.65= 1.65
，
OFF =3*1.65 =4.95 (rounded value) =2 seconds ON / 5 seconds OFF
This tool is intended for a duty cycle of 2.0 sec on, 5.0 sec off.
(5)
Under Pressure
L-TYPE
P-TYPE
(1)
(5)
(2)
(3)
(4)
(6)
(7)
(8)
(1)
(2)
(3)
(4)
(6)
(7)
(8)
