25
6.2 Date transfer
6.2.1 Data format
Output data are outputted in the ASCII format with a USB cable.
In addition, in order to take in data, driver software needs to be installed separately.
About installation of driver software, please refer to http://www.ftdichip.com/Drivers/VCP.htm
Data Format
6.3
All Elimination of Saved Data
1. When carrying out package elimination of all the data, it continues pressing CLEAR until it displays as
.
(About 4 seconds)
2. If the CLEAR key is again pressed during
blink, it will be indicated by blink with
.
3. If the CLEAR key is pressed again, it will be displayed as
and all data will be eliminated.
(The setting numerical value of each function is not cleared)
※
When operation is left during
・
blink, it will be in the state which can be measured.
(Memory is not cleared)
Change of Output Speed of Data
The speed of the output at the time of outputting the data saved can be changed.
A. For Printer Output (Low Speed) -- Setup "00"
B. For Personal Computer Output (High Speed) -- Setup "01"
This setup is adapted also for the change of the output timing of real-time output mode.
A. Low Speed (Every about 1 / 12 Seconds) -- Setup "00"
B. High Speed (Every about 1 / 180 Seconds) -- Setup "01"
(It is set as "01" at the time of purchase.)
The change of a setup is performed by the following methods.
1. In the state of a power source OFF, pressing the PRG key, press the ON/OFF key and switch on a power source.
2. If the PRG key is released, it will be displayed as "01" or "00."
Since it will change if UP key is pressed, a setup is chosen.
3. If the PRG key is pressed again, after displaying it as
, it returns to a torque display, and will be in the state
which can be measured.
Data bit length
start bit 1 + data bit 8 + stop bit 2 + no parity
Baud rate
19200bps
Connector form
USB (B type)
Summary of Contents for KTM-15
Page 30: ... ...
