23
『
6
』
press PRG/SET once again, setting buzzer, UP/DOWN setting.
(ON: normal sound, OFF: no sound, FF: sound comes only under abnormal situation)
Setup of Buzzer
：
※
SETTING OK
UP
UP
After displaying
, an ON-OFF-FF setup of a buzzer is displayed. How to sound a buzzer is set up by UP/DOWN.
(
：
Sound altogether.
：
No sounds.
：
Only NG sounds.)
If a setup is completed, the PRG/SET key will be pressed again.
5.2
After setting
PRG/SET
Alarm
Less than minimum value
Between minimum value
and maximum value
Over maximum value
Excess torque
LED
Red blink (Slow)
Green light (Good)
Red blink (Quick)
Red light (NG)
BUZZER
Interrupted sound (Slow)
Continuous sound
Interrupted
sound (Quick)
Continuous sound
※
Maximum Value, minimum value, average value
We can take advantage of the AVE key to test maximum value, minimum value and average value. (you can test at most 30 datum).
1.
Be sure the test mode is
『
PP
』
or
『
PD
』
, not TRACK.
2.
Press AVE key to make re-testing, the
『
AVE
』
will blink on the LCD.
3.
After several tests. (at most 30 numbers)
4.
Press AVE again, the LCD will automatically display the counting numbers —MAX—MIN—AVE.
The counting numbers (at most 30 numbers), there is no display on the LCD
MAX
Max, 0.650, will be shown on the LCD
MIN
Min, 0.500, will be shown on the LCD
AVE
Ave, 0.600, will be shown on the LCD
※
If measurement over 30 times. Can be displayed [n+001], [n+002]
……
When measuring more than 30 times, it's eliminated from old data.
【
Example
】
[n+001] (The 31
st
times)
Total 30 times, it's calculated from the 2nd to the 31st.
6
、
Data saving, display, output
Whenever pressing, CLEAR key will automatically clear and save memory.
At the same time signal will automatically output if USB is used.
Summary of Contents for KTM-15
Page 30: ... ...
