Kilews KTM-15, Instruction Manual

Page: 23 / 30

22
5.1 Setting procedure:
『
1
』
press PRG/SET key approximately one second, green LED light will be on and getting into set screen. LCD monitor will
display “ ” and jump to 0.0.
Press DOWN key, then the value of fourth digit can be set. The change of value is only allowed to increase. If needing increase,
press UP key. If changing second digit, please press DOWN key shown as following the drawing:
FOR EXAMPLE
Setting maximum limit as 0650
：
DOWN DOWN UP 6 Times DOWN UP 5 Times DOWN
『
2
』
press PRG/SET once again, setting minimum torque value limit, LCD will display “ ” and jump to 0.0 again, press
again DOWN key
Setting minimum limit as 0500
：
DOWN DOWN UP 5 Times DOWN DOWN
『
3
』
press PRG/SET once again, set the initial value of PD, if the initial value is less than set value, the value will not be recorded.
(It is only applying to PD mode)
Setting the PD mode initial value as 0300
：
DOWN DOWN UP 3 Times DOWN DOWN
『 4 』
press PRG/SET once again. After displaying , a real-time output start value is displayed. A value is set up similarly.
When this value is set to 0, the inside of real-time output mode continues outputting data.
Setting the real-time output start value as 0.010
：
『 5 』
press PRG/SET once again, set clear switch with “ ” and press UP/DOWN to set the time for auto clear.
Setting the time for auto clear (0.0C
⇔
0.1C
⇔
0.5C
⇔
1.0C
⇔
1.5C
⇔
2.0C
⇔
2.5C
⇔
3.0C
⇔
0.0C), but if the time be set to 0.0C
needs to press CLEAR to clean the value.
Setting clear with one second
：
UP
/
DOWN
Press about one second, LED will be on.
Press DOWN 3 times.
The second figures blink. Press UP 8 times.
The second figures blink by "
1".