2
SETUP
TOS8870A
Chapter 1
SETUP
This chapter describes unpacking and general preliminary notes and precautions.
1.1 Checking for Shipping Damages and
Accessories
■
Unpacking
The Tester should be checking upon receipt for damage that might have occurred during transporta-
tion. Also check that all accessories have been provided.
Should the Tester be damaged or accessory missing, notify your Kikusui agent/distributor.
■
Packing
•
When transporting the Tester, be sure to use the original packing materials. If they
are missing, contact your Kikusui agent/distributor.
•
When packing the Tester, remove the power cord and all other connection cables.
1.2 Precautions for Installation
Be sure to observe the following precautions when installing the unit.
■
Do not use the unit in a flammable atmosphere.
To prevent explosion or
fi
re, do not use the unit near alcohol or thinner, or in an atmosphere con-
taining such vapors.
■
Avoid locations where the unit is exposed to high temperature or direct
sunshine.
Do not locate the unit near a heater or in areas subject to drastic temperature changes.
Operation temperature range: 0
˚
C to 40
˚
C
Storage temperature range: -20
˚
C to 70
˚
C
■
Avoid locations of high humidity.
Do not locate the unit in high-humidity locations, i.e., near a boiler, humidi
fi
er, water supply, etc.
Operation humidity range: 20 % to 80 % RH (without condensation)
Storage humidity range: 80 % RH or less (without condensation)
Dew condensation may take place even in the operation humidity range. In such a case, do not use
the unit until the dew dries up completely.
Accessories
Item
Parts No.
Q'ty
Check
Power cord
85-AA-0003
1
TL01-TOS High Voltage Test Leadwires
(Approx.1.5m)
KA-0607-02
1
“DANGER High-Voltage” sticker
A8-210-202
1
Operation Manual
Z1-002-472
1
注意
CAUTION
