6
WARNINGS AND CAUTIONS FOR OPERATING THE TESTER
TOS8870A
Chapter 2
WARNINGS AND CAUTIONS FOR
OPERATING THE TESTER
This Chapter gives warnings and cautions when operating the Tester. When operating the Tester, be
extremely careful and observe the cautions, warnings, and other instructions given in this chapter.
•
The Tester delivers maximum 5 kVAC or 1 kVDC or higher test voltage, which can
cause a fatal accident if it is not handled properly. When operating the Tester, be
extremely careful and observe the cautions, warnings and other instructions given in
this chapter.
2.1 Preparative Procedures
2.1.1 Wearing Insulation Gloves
When handling the Tester, be sure to wear insulation gloves in order to protect yourself against high
voltages. If no insulation gloves are available on your market, please order your Kikusui agent/dis-
tributor for them.
2.1.2 Grounding the Tester
Be sure to ground the Tester. Unless the Tester is securely grounded, when the Tester output is
shorted to an earth line or to a conveyor or other device which is connected to an earth line or when
it is shorted to the AC line, the Tester chassis can be charged up to the high voltage that can cause
electric shock hazard.
Fig.2-1
Protective conductor terminal
•
The term "AC line" here means the line on which the Tester is operating. That is the line to
whose outlet the AC power cord of the Tester is connected. It may be of a commercial AC
power line or of a private-generator AC power line.
WARNING
FA I L AL AR M
MOMENTARY
PASS HOL D
DOUBLE ACTION
TEST MODE
READY
TEST
SIGNAL OUT
PASS ACW / FA I L I R / FA I L
KIKUSUI ELECTRONICS CORP.
MADE IN JAPAN
WARNING
TO AVOID ELECTRIC SHOCK, THE POWER CORD PROTECTIVE GROUNDING
CONDUCTOR OR THE PROTECTIVE CONDUCTOR TERMINAL MUST BE
CONNECTED TO GROUND.
DO NOT REMOVE COVERS, REFER SERVICING TO QUALIFIED PERSONNEL.
警告
感電事故防止のため、入力電源コードのGND線、又は本製品の接地端子 を確実に
接地してご使用ください。
本製品のカバーは絶対に取り外してはいけません。
WEIGHT APPROX 23kg
CURRENT
MONITOR
LOW
HIG
INTER-
LOCK
AC L INE
BUZZER
IF THIS COLUMN IS BLANK ,THE UNIT IS WIRED IN 100V
100V
LINE VOLTAGE
STANDARD
SE T TING
SUPPLY
FREQUENCY
VA
MAX
110V
120V
800
220V
230V
240V
50
60Hz
Protective conductor terminal
DESCRIPTION
