PLZ-5W 3
Connecting the Power Cord
WARNING
Risk of electric shock.
• The PLZ-5W conforms to IEC Safety Class I (equipment
that has a protective conductor terminal). Be sure to
earth ground the product to prevent electric shock.
• The PLZ-5W is grounded through the power cord
ground wire. Connect the protective conductor terminal
to earth ground.
─ Note ─
• Use the supplied power cord to connect to the AC line. If the
supplied power cord cannot be used because the rated voltage
or the plug shape is incompatible, have a qualified engineer
replace it with an appropriate power cord that is 3 m or less in
length. If obtaining a power cord is difficult, contact your Kikusui
agent or distributor.
• The power cord with a plug can be used to disconnect the
PLZ-5W from the AC power line in an emergency. Connect the
plug to an easily accessible power outlet so that the plug can be
removed from the outlet at any time.
• Secure adequate space around the power cord plug. Do not
insert the power cord plug into an outlet that is difficult to ac
-
cess or place objects around the power cord plug that will make
plugging and unplugging difficult.
• Do not use the supplied power cord with other instruments.
The PLZ-5W conforms to IEC Overvoltage Category II
(energy-consuming equipment that is supplied from a fixed
installation).
1
Turn the POWER switch off ( ).
2
Check that the AC power line meets the nominal
input rating of the PLZ-5W.
The PLZ-5W can receive a nominal line voltage in the range
of 100 Vac to 240 Vac at 50 Hz or 60 Hz.
3
Connect the power cord to the AC INPUT inlet on
the rear panel.
4
Connect the power cord plug to a properly
grounded outlet.
Safety Precautions
When using this product, be sure to observe the “Safety
Precautions” in the Safety information manual. The follow-
ing precautions pertain only to this product.
• The rear panel may become hot during operation. If you
touch it, you may burn yourself.
Precautions Concerning
Installation Location
When installing this product, be sure to observe the
“Precautions Concerning Installation Location” in the
Safety information manual. The following precautions per-
tain only to this product.
• When installing this product, be sure to observe the tempera-
ture and humidity ranges indicated below.
Operating temperature range: 0 °C to 40 °C
Operating humidity range: 20 %rh to 85 %rh (no
condensation)
• When storing this product, be sure to observe the tempera-
ture and humidity ranges indicated below.
Storage temperature range: -20 °C to 70 °C
Storage humidity range: 90 %rh or less (no condensation)
• Do not install the product vertically.
It may cause injury to the operator or damage to the product
when it falls down.
