Kikusui DSI1020, Installation Manual, Page: 11 / 64

DSI1020/ DSI3020
11
Overview of the Test System
AC power supply and firmware version
The following AC power supplies can be used.
Communication interface (this product and AC power supplies)
The following communication interfaces can be used.
Single-phase three-wire and three-phase output drivers (PCR-LE
options)
The following options are not necessary if you are using a PCR-LE2 series AC power supply.
 For single-phase three-wire output
Prepare two AC power supplies (used as a U-phase unit and V-phase unit). Then, install
a single-phase three-wire output driver (2P05-PCR-LE) in SLOT 1 of each unit.
 For three-phase three-wire or three-phase four-wire output
Prepare three AC power supplies (used as a U-phase unit, V-phase unit, and W-phase
unit). Then, install a three-phase output driver (3P05-PCR-LE) in SLOT 1 of each unit.
Sync signal interface
Install the control board supplied with this product in SLOT3 of the (master) AC power supply.
Application software for controlling the test system
Use the SD009-PCR-LE Quick Immunity Sequencer 2 application software to control the test
system.
AC power supply Firmware version
PCR-LE Series 3.0 and later
PCR-LE2 Series 4.0 and later
CAUTION
This product cannot be combined with custom-order AC power supplies with built-in EMI
filters.
Doing so can cause a malfunction.
Communication interface This product AC power supplies
RS-232C Standard
Standard (terminal in the top section
of the front panel)
GPIB Factory option
IB05-PCR-LE (option)
1
1 The optional communication interface board is installed in SLOT 4 of each AC power
supply. For details, see the AC power supply manual.
USB Factory option
US05-PCR-LE (option)
1
LAN —
LN05-PCR-LE (option)
1
Use the cables supplied with the drivers to connect between the single-phase three-wire or
three-phase output driver connectors. For details, see the setup guide of the driver.