19
1 x
Side Top 1 x 4 x 51-1/2”
Step 4: Swing Side Assembly
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
H2
2 x
Post 2 x 4 x 74”
1 x
SW Ground 1 x 5 x 60-1/4”
1 x
SW Floor 1 x 6 x 26-7/8”
1 x
Lower Diagonal 2 x 3 x 37”
1 x
SW Mount 2 x 4 x 60”
Hardware
Wood Parts
11 x
1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
2 x
5/16 x 4” Hex Bolt (5/16” lock washer, 5/16” flat washer, 5/16” t-nut)
1 x
1/4 x 3” Lag Screw (with 1/4” flat washer)
2 x
#8 x 1-1/2” Wood Screw
LS3
Fig. 4.1
Notice hole
location
H2
H2
LS3
G4
H2
H2
G4
Fig. 4.2
A:
To 2 (1771) Posts attach (1770) SW Ground and (1759) SW Floor using 4 (H2) 1/4 x 2” Hex Bolts (with lock
washer, flat washer and t-nut) in each board.
Be sure to keep bolts loose.
(fig. 4.1)
B:
Attach (1797) Side Top to each
(1771) Post with 2 (H2) 1/4 x 2” Hex
Bolts (with lock washer, flat washer and
t-nut) Hex Bolts are to be installed from
the back of the assembly.
Be sure to
keep bolts loose.
(fig. 4.2)
C:
Make sure assembly is square and
then fasten (0369) Lower Diagonal to
(1770) SW Ground at an angle using 1
(H2) 1/4 x 2” Hex Bolt (with lock washer,
flat washer and t-nut) and to (1771) Post
using 1 (LS3) 1/4 x 3” Lag Screw (with
flat washer). (fig 4.2).
D:
Attach (2782) SW Mount to (1759)
SW Floor and (1797) Side Top with
2 (G4) 5/16 x 4” Hex Bolts (with lock
washer, flat washer and t-nut). (fig. 4.2)
E:
Tighten all bolts then attach (1797)
Side Top to each (1771) Post with 1 (S2)
#8 x 1-1/2” Wood Screw per post. (fig.
4.2)
H2
1771
1797
1770
1759
0369
2782
1771
1759
1770
1797
1771
1759
0369
1770
H2
G4
1771
2782
S2
S2
S2
Summary of Contents for F24148E
Page 42: ...NOTES 42 42...
Page 43: ...NOTES 43 43...
