Step 19 Ground Stakes
Step 21: Attach Ground Stakes
STEP 18
Attach Rope Ladder
STEP 19
Attach Slide and Acro Swing
A:
Drive 1 (A36) Ground Stake 10-1/2” into the ground at each (A35) SW Post on the inside of the assembly and
attach with 2 (S3) #8 x 2-1/2” Wood Screws per ground stake. (fig. 21.1 & 21.2)
B:
Drive 1 (A36) Ground Stake 10-1/2” into the ground beside the 2 (A20) Corner Posts shown in fig. 21.1, on the
inside of the assembly and attach with 2 (S3) #8 x 2-1/2” Wood Screws per ground stake. (fig. 21.1 & 21.3)
C:
Inspect for open 3/8” holes. Insert Hole Plugs into all unused holes. (fig. 21.4)
Use an extra
Flat Washer
If Bolt protrudes
beyond T-Nut
Warning! Check entire play centre for
bolts protruding beyond T-Nuts. Use
extra washers to eliminate this condition.
Step 19 Ground Stakes
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 10-1/2” into ground.
Digging or driving stakes can be dangerous if you
do not check first for underground wiring, cables
or gas lines.
Fig. 21.1
Fig. 21.2
S3
A36
A35
Fig. 21.4
A20
A36
A35
A36
Step 19 Ground Stakes
A20
A36
Fig. 21.3
4 x
Ground Stakes 1-1/4 x 1-1/2 x 14”
A36
Hardware
Wood Parts
8 x
#8 x 2-1/2” Wood Screw
S3
Other Parts
4 x Hole Plugs
10-1/2”
36
S3
