Step 2 Left Wall Asy
Step 5: Left Wall Assembly
A:
To the 2 remaining (A20) Corner Posts attach 1 (A25) Lower Side and 1 ( A14) SW Floor with 4 (H2) 1/4 x 2”
Hex Bolts (with lock washer, flat washer and t-nut) per board and 1 (A29) Side Top with 2 (H2) 1/4 x 2” Hex Bolt
(with lock washer, flat washer and t-nut) in the top holes. (fig. 5.1)
Be sure to keep bolts loose.
B:
Make sure assembly is square and then in the bottom holes of the (A29) Side Top fasten to each (A20) Corner
Post using 2 (S2) #8 x 1-1/2” Wood Screws. (fig. 5.1)
C:
Attach (A12) Lower Diagonal to (A25) Lower Side with 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, flat washer
and t-nut). Make sure assembly is still square and then attach to (A20) Corner Post using 1 (LS3) 1/4 x 3” Lag
Screw (with flat washer). (fig. 5.1)
D:
Attach 1 (A18) Corner Block flush to the end of (A25) Lower Side with 2 (S2) #8 x 1-1/2” Wood Screws. (fig.
5.1)
Pre-drill all pilot holes using a
1/8” drill bit before installing
the lag screws.
Fig. 5.1
A14
LS3
A20
A29
A25
A20
Notice hole
location
S2
S2
H2
H2
H2
H2
A18
S2
Hex Bolt Assembly
Lock
Washer
T-Nut
Flat
Washer
Hex
Bolt
Predrill Pilot Holes for Lag Screw
Lag
Screw
Flat
Washer
Predrill 1/8”
pilot hole
Use factory drilled
hole as a guide
2 x
Corner Post 2 x 4 x 83”
1 x
Lower Side 1 x 5 x 62-3/8”
1 x
SW Floor 1 x 6 x 26-7/8”
1 x
Side Top 1 x 4 x 51-1/2”
1 x
Lower Diagonal 2 x 3 x 37”
A20
Hardware
Wood Parts
11 x
1/4 x 2” Hex Bolt
(1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
4 x
#8 x 1-1/2” Wood Screw
1 x
1/4 x 3” Lag Screw (with 1/4” flat washer)
H2
A25
A14
A29
S2
A12
LS3
1 x
Corner Block 2 x 3 x 4-1/2”
A18
A12
18