26
Fig. 11.1
Step 11: Front Frame Assembly
A:
On the front side of the assembly, from the inside, attach (1908) Front Floor to each (1931) Post with 2 (H6)
1/4 x 4-3/4” Hex Bolts (with lock washer, flat washer and t-nut). (fig. 11.1 and 11.2)
B:
Flush to the bottom of (1908) Front Floor attach (1937) Centre Divider with 1 (H12) 1/4 x 3” Hex Bolt (with
lock washer, flat washer and t-nut). (fig. 11.2)
C:
Attach (1937) Centre Divider to (2037) Front Top using 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, flat washer
and t-nut). (fig. 11.2)
D:
Make sure (2037) Front Top is square and level and then attach to both (1931) Posts using 4 (S7) #12 x 2”
Pan Screws (with 3/16” flat washers). (fig. 11.2)
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
E:
Attach (1768) Lower Back to the bottom of (1931) Posts with 2 (LS3) 1/4 x 3” Lag Screws (with flat washer) in
the top (pre-drilled) holes and 2 (S7) #12 x 2” Pan Screws (with 3/16” flat washers) in the bottom holes as shown
in fig. 11.3.
Wood Parts
Hardware
Fig. 11.2
Back
Fig. 11.3
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
H2
1 x
1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
2 x
1/4 x 4-3/4” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
1 x
1/4 x 3” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
6 x
#12 x 2” Pan Screw (3/16” flat washer)
1 x
Front Top 1 x 5 x 38-1/2”
1 x
Centre Divider 2 x 2 x 31-3/4”
1 x
Front Floor 2 x 3 x 38-1/2”
1 x
Lower Back 1 x 5 x 38-1/2”
2037
S7
H2
H12
H6
1931
1908
1937
H6
with 3/16”
Flat Washer
H6
with 3/16”
Flat Washer
1931
2037
1937
1908
S7
S7
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
H12
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
1768
2 x
1/4 x 3” Lag Screw
(1/4” flat washer)
LS3
S7
LS3
S7
LS3
with 3/16”
Flat Washer
1/4” Flat
Washer
with 3/16”
Flat Washer
1/4” Flat
Washer
Cafe Wall
Front
Swing Wall
1768
