KIDDY Evolution Pro, Directions For Use Manual

Page: 29 / 117

7. Use in the vehicle
7.1 In-vehicle installation with seatbelt
7.1.1 Seat selection
Read up all the necessary information about the use of child
restraint systems in your vehicle owner’s manual.
The Kiddy evolution pro child restraint system can be installed on any seat
of vehicles equipped with a 3-point belt system (Fig. 12).
If you want to install the child restraint system in the
passenger seat, the airbag must be deactivated or you will have
to use a different seat.
7.1.2 Installation steps with the seatbelt
Place your Kiddy facing the rear and with the handle in the carry
position on a seat without an active front airbag and with a 3-point
belt (Fig. 13).
Before starting the journey, please always make sure that the harness is put
on and tightened correctly.
Pull the vehicle seatbelt out and feed the lap belt through both lap belt
guides and press the safety belt lock tongue into the buckle (Fig. 14)
with a clearly audible click. Check that everything is locked into place.
Tighten the lap belt (Fig. 14).
Now place the shoulder belt around the infant carrier and feed it through
behind the front cover of the infant carrier (Fig. 15).
Make certain that the belt clip is in the correct position.
8
*
ENG