more information refer to section 4, OPERATION AND TESTING.
If the alarm does sound, check for fires first. If a fire is discovered,
get out and call the fire department. If no fire is present, check to
see if one of the reasons listed in section 2 may have caused the
alarm.
6. MAINTENANCE
ALARM REMOVAL
IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER TO
TAMPER RESIST FEATURE DESCRIPTION IN SECTION 3 FOR
PIN REMOVAL INSTRUCTIONS.
To replace the battery, remove the alarm from the trim ring by
rotating the alarm in the direction of the “OFF” arrow on the
cover. To disconnect the AC power harness, squeeze the locking
arms on the sides of the Quick Connector while pulling the connec-
tor away from the bottom of the alarm (see section 3, figure 5).
BATTERY INSTALLATION AND REMOVAL
To replace or install the batteries you must first remove the alarm
from the trim ring by following the ALARM REMOVAL instructions
at the beginning of this section. After alarm has been removed,
you can open the battery door and install or replace the battery.
Battery installation instructions are provided on the inside of the
battery door.
When installing the battery, press the battery reminder finger
down into the battery compartment and install the battery (see
figure 5).
CAUTION! IF THE BATTERY REMINDER FINGER IS NOT HELD
DOWN IN THE BATTERY COMPARTMENT BY THE BATTERY,
THE BATTERY DOOR WILL NOT CLOSE, THE AC QUICK
CONNECTOR WILL NOT ATTACH TO THE ALARM, AND THE
ALARM WILL NOT ATTACH TO THE TRIM RING.
The Model PI2010 Smoke Alarm is powered by a 9V alkaline bat-
FIGURE 8
Battery
Reminder
Finger
1475-7205-00(820-0905-EN)_R1.indd 11
1475-7205-00(820-0905-EN)_R1.indd 11
2009.12.9 10:07:38 AM
2009.12.9 10:07:38 AM
