6
20. Plug the amplifi er harness into the amplifi er and install the amplifi er in the dash by sliding
the two ¼” bolts on the amp bracket into the slotted holes on the dash support brace by the
factory grounding point and then lining up the hole on the top of the bracket with the hole in
the dash frame. Insert the supplied 7mm screw and tighten. Fig. 13
21. Then tighten the two bolts that were aligned in the slotted holes Fig. 14
22. Remove the factory 10mm bolt from the factory grounding point next to the amplifi er and
connect the black ground wire for both the subwoofer and amplifi er harness. Torque to 5Nm.
Fig. 15
23. Route the amp harness to the radio opening
24. Connect the male radio harness connecter to the female connecter of the amp harness
and tuck this connection out of the way to avoid interference with radio during reinstallation.
Fig. 16
25. You can now connect the radio to the amp harness and reconnect the antennae wire
and reinstall the radio.
26. Plug the power wire connector on the amplifi er harness to the connector you installed on
the wires coming from the under the hood.
27. Connect the subwoofer output spade terminals of the amplifi er harness to the corre-
sponding spade terminals of the subwoofer harness.
Fig. 15
Fig. 16
Fig. 14
Fig. 13
