8
In this confi guration, the Front Row is used to drive your tweeters, midrange/midbass drivers and subwoofers
separately; each with their own amplifi er, crossover points and time alignment. Use this confi guration with a set of
components that require active crossovers and independent time alignment.
Set the FRONT FREQUENCY switch to a factor of
X10
and adjust the HI-PASS crossover for tweeter use
(Recommended starting point of 3KHz).
Confi gure the REAR/SURROUND channel for mids by using the crossovers as a band-pass fi lter. Set the LO-
PASS switch to ON and the FREQUENCY switch to a factor of
X10
, then adjust both the HI-PASS and LO-PASS
crossovers accordingly (Recommended starting points of 80Hz and 3KHz, respectively).
Adjust the SUBWOOFER channel’s
LO-PASS crossver to 80Hz.
This confi guration allows you to time
align your left mid/mid-bass speaker
and left tweeter separately for
an optimal driver’s-side listening
experience. You will not be able to
use the Surround Sound function
and it should be turned
OFF
.
Once the crossovers and OUTPUT
LEVEL controls on your Front Row
are confi gured, use the remote
control to fi ne-tune the sound.
INPUT
GAIN
MIN MAX
10 500Hz
50 500Hz
40 160Hz
0° 180°
10 500Hz
10 80Hz
MIN MAX
MIN MAX
MIN MAX
MIN MAX
MIN MAX
OUTPUT
LEVEL
OUTPUT
LEVEL
LO-P
ASS
X-OVER
HI-P
ASS
X-OVER
HI-P
ASS
X-OVER
SUBSONIC
PHASE
FREQUENCY
dB/OCT
LO-P
ASS
CLIP LIMITER
CLIP LIMITER
DC OFFSET/12V
CLIP LIMITER
OFF/ON
OFF/ON
OFF/LO
OFF/ON
TURN-ON
FREQUENCY
48/24/12
48/24/12
48/24/12
1X 10X
1X 10X
dB/OCT
dB/OCT
LO-P
ASS
X-OVER
OUTPUT
LEVEL
INPUT CLIP
POWER
FRONT
REAR/SURROUND
SUBWOOFER
INPUT
GAIN
INPUT
GAIN
INPUT CLIP
INPUT CLIP
High, Mid and Low wiring
factory source unit /
factory amplifi er
Front Row
full-range signal
sub channel
high-channel
(tweeters)
mid-channel
2 or 4-channel
full-range amplifi er
2 or 4-channel
full-range amplifi er
subwoofer amplifi er
full
sub
2012 FrontRow (ZXDSP) Rev G.indd 8
2012 FrontRow (ZXDSP) Rev G.indd 8
4/30/2012 1:55:50 PM
4/30/2012 1:55:50 PM
