6
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Genesis
®
Desking - Wire Management Troughs & 10-Wire Electrical System
Assembly Instructions
Genesis Wire Management
Troughs & 10-Wire Electrical
System
Note:
The troughs come fully
assembled and ready for attachment
to the base legs. Some disassembly
may be required for the installation of
some components such as 10-wire
duplex receptacles, 10-wire rigid
wireways, end-of-run trough caps
and/or trough joiners.
Note:
Before assembling electrical
components, troughs should be
assembled to the desk legs. If wire
trough is not installed to the desk
legs, reference “Cross Brace and/or
Wire Trough Installation” instructions
on page 4.
1. See Figure 12 for trough
components.
2. See Figure 13 for electrical
components.
2
10-24 x / ”
Torx head screw
(one per clip)
1
4
#8 x / ”
Phillips head
screw
5
8
10-wire
rigid wireway
attachment clip
(two per wireway)
10-wire duplex
receptacles
(typically four
per wireway)
10-wire rigid wireway
(approximately 15 / ” shorter
than table width)
3
8
trough
assembly
(straight)
table-to-table
trough joiner
10-wire infeed
(replaces one receptacle)
end-of-run
trough cap
infeed replaces one
of the bottom 10-wire
duplex receptacles
two 10-wire
duplex
receptacles
inside trough
two 10-wire duplex
receptacles out through
bottom of trough
trough access
by opening
door
opening along entire
length of spline for
easy drop in cord
management
Figure 13
interior
cover
access door
extrusion
right-hand
back cover
trim casting
back cover
extrusion
all other trough
assembly screws
are #10-24 x / ”
Torx drive
1
4
mitered door trim
(does not open)
(corner & shoe tables only)
left-hand
back cover
trim casting
1
5
/ -20 x / ”
screw for leg
attachment
4
8
leg attachment tab
is bent for tripod
post leg attachment
Figure 12
