12
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Genesis
®
Desking - Transaction Worksurface
Assembly Instructions
Transaction Worksurface
Attachment
1. Remove appropriate worksurface
grommets and covers. Remove the
two outside
5
/
16
-18 x 2” short-head
bolts from the bolt cluster that
secures the worksurface to the leg
supports. The center bolt does not
require removal and can be loosened
approximately
1
/
8
” and left in place.
Repeat on other end of worksurface
(Figure 27).
2. Place transaction worksurface
laminate side down on a soft,
protective surface to avoid
scratching. Align small holes in
transaction stanchion with drilled
holes near outside of transaction
worksurface and secure with two
#14 x 1” Phillips self-tapping
screws per support. Align holes in
transaction stanchion plate (flanges
facing toward inside of desk)
with drilled holes in underside of
worksurface and secure with three
#14 x 1” screws per panel
(Figure 27).
3. Set transaction worksurface assembly
onto desk assembly and hook
transaction worksurface support slots
onto heads of the
5
/
16
-18 x 2”
short-head bolts. Secure with
remaining
5
/
16
-18 x 2” short-head
bolts and tighten (Figure 27).
leg support
worksurface
transaction worksurface
stanchion
#12 x 1”
#14 x 1”
Phillips pan head
sheet metal
screw
Figure 27
5
/ -18 x 2”
short-head
bolts
16
